Malibu - Access Control Extension Panel - 4 Doors - UL Listed

This UL Listed panel control 4 doors via RFID card access and managed by the easy-to-use Malibu access control module. It is a power supply/charger which converts a 115VAC/60Hz input into a single 12VDC or 24VDC non power-limited output. Mounting magnets are included to accommodate screws and nylon standoffs to allow for mounting various boards/accessories in any metal enclosure or back plane.

**Back up battery not included**

Note: Must have the UL Listed 4 door controller with module (MAC-004-ALCM) to use this extension. The 4 door controller with module controls the first 4 doors and this extension allows you to add 4 additional doors either in the same or different location. (additional multiples of 4 doors require an extension for each set.)

Each door requires a Monthly Licencse Fee Per Door Please be sure to manually add a monthly subscription for each door needed. 

Now this Module has Mobile Credentials.  The mobile credential can be setup with the same access level as a normal RFID card.  Download the "Malibu Mobile Credential"app to use your phone for access control.  It doesn't use Bluetooth.  It's the most simple yet secure mobile credential on the market. 

Features:

• Input 115VAC, 60Hz, 3.5A
• Output 12VDC or 24VDC selectable output
• 6A continuous supply current
• Filtered and electronically regulated output
• Short Circuit and thermal overload protection
• Built-charger for sealed lead acid or gel type batteries
• Automatic switch over to stand-by battery when AC fails
• AC fail supervision (form "C" contacts)
• Notification trigger is selectable for 30 seconds (factory set) or 6 hours
• Low battery supervision (form "C" contacts)
• Battery presence supervision (form "C" contacts)
• AC input and DC output LED indicators
• Operating 0° C to 49° C (32° F to 120° F)
• Storage - 20° C to 70°C ( - 4° F to 158° F)
• Relative Humidity 85% +/- 5% (BTU/Hr[approx] 12VDC: 37 BTU/Hr, 24VDC: 74 BTU/Hr)
• System AC input VA requirement: 402.5VA
• Wall mount enclosure for indoor use
• Accommodates up to two (2) 12VDC/7AH Batteries
• Dimensions 13"W x 13.5"H x 3.25"D (330mm W x 343mm H x 83mm D)
• 1/2" and 3/4" combination knockouts
• Customize the metal enclosure or back plane to accommodate power supplies, distribution boards, access controllers, and accessories
• Easy, fast installation saves time and labor - no drilling required
• Can be reused and re-positioned
• Zinc alloy cover eliminates the possibility of EMI/RFI
• 26 lbs max strength
• 23.2mm (1") diameter cup, 6.5 mm hole size
• Includes hardware (screws and standoffs)

Specifications:

Package Includes: 

• 1 x Access Control Board
• 1 x Power Supply
• 1 x panel Enclosure
• 4 x mounting Magnets

Downloads:

• Panel and Power Supply
• 4 Door Controller Board
• Installation Instructions